We sort out frequently asked questions (FAQ) as follows, and please contact us if you have other questions.
Transmission protection device and reset of paper claw row and operating mode:This device aims to guarantee machine service life and operational safety; when paper claw fails to operate normally due to block of external force, protection device will trip and indicator lamp of proximity switch S1 will be on and machine immediately stops running.1.First close key-lock switch and operate when flywheel completely stops running and block faults are all removed.2.Open small lid at the front end of machine back side. (Figure A)3.Rotate brake switch (Figure D) to off-position and brake release sound can be heard.4.Insert rotation handle into center shaft hole of flywheel. (Figure C)5.Rotate flywheel handle, middle mold shaking base can descend to bottom dead centre and then torque limiter can be reset.6.In case that middle mold shaking base arrives at the lowest point and still fails to reset, YD0913 attachment and rotating open end wrench shall be used until reset is done and indicator lamp is off (Figure B). (If tripping clearance has been restored and indicator lamp is still on, pay special attention to whether proximity switch S1 is damaged or torque limiter isn’t reset).7.After the above operation is done, please rotate pulley (clockwise) to examine operating situation of paper claw row; in case of normal operation, start up for operation after switching back brake switch to reset location.When rotation handle and wheel gear B and C are unused, it is strongly prohibited to leave them at flywheel for fear of danger.
1.Red lamp- it is on when main motor starts. In case of inchellong or continuous operation alarm, red lamp flashes; after the alarm is done, the red lamp still remains on.2.Yellow lamp—in case of abnormal condition, yellow lamp flashes for alarm.3.Green lamp-green lamp is on when power is on but main motor fails to start.